Replacement Part List

10 Section 4 — ASSembly & inStAllAtion
Figure 4-10
Figure 4-11
12. Clip in the other side by flexing the screen and pushing it
down into the provided cutout hole. See Figure 4-8.
Make sure screen sits under the cover’s lip
Figure 4-8
13. Install the bagger cover onto the bag support assembly, as
seen in Figure 4-9. The plastic cover goes inside of the two
mounting tabs.
Cover mounts in
between these
two tabs
Figure 4-9
14. Slide the hinge pin into the hole located on the mounting
tab, as in Figure 4-10. Use the cut-out window (See inset in
Figure 4-10) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Figure 4-11.