Instructions / Assembly

9Section 4 — ASSembly & inStAllAtion
4. Install the bagger hanger assembly onto the mounting
assembly on the tractor by hooking it over the hitch plate,
as shown in Fig. 4-4. Align the hanger assembly with the
hole just to the right of the center hole, as detailed in the
inset of Fig. 4-4.
5. Secure the hanger assembly to the mounting assembly using
a 5/16” bolt and flange nut packed in with this upright
bagger support. See Fig. 4-5.
IMPORTANT: Use the mounting hole to the right of the center
hole, as detailed in the inset of Fig. 4-4.
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
1. Snap the plastic upper chute suppor t in place by first clipping
the side portion onto the bagger support rail (1) with the
edge of the snap feature aligned with the line on the label,
as shown in the inset of Fig. 4-6.
2. Snap the front side of the chute support to the rail (2), as
shown in Fig. 4-6.
3. Install the bagger screen into the bagger cover by first inserting
one end into the corresponding cutout mounting hole, as
in Fig. 4-7. Make sure to feed the screen under the lip, as in
Fig. 4-8.
Figure 4-4
Figure 4-5
1
2
Figure 4-6
Figure 4-7