Instructions / Assembly

10 Section 4 — ASSembly & inStAllAtion
4. Clip in the other side of the screen by flexing the screen and
pushing it down into the other corresponding cutout hole,
highlighted in Fig. 4-8.
5. Install the bagger cover onto the bag support assembly, as
seen in Fig. 4-9. The plastic cover goes inside of the two
mounting tabs.
6. Slide the hing e pin into the hole l ocated on th e mounting tab, as
in Fig. 4-10. Use the cut-out window (See inset in Fig. 4-10)
to line up the hinge pin on the other side and push pin all
the way in until it reaches the end-stop. At this point the
pin clips into place and is secured by a tab in the bagger
cover. See Fig. 4-11.
Cover fits inside of the
two mounting tabs
Figure 4-8
Figure 4-9
Figure 4-11
Figure 4-10
Make sure screen sits under the cover’s lip