Use and Care Manual

6
ENGLISH
16. Calibratetheowcontrolsetting.(Seegure10).
a. Pushowcontrolarmto"OFF"position.
b. Slideowcontrolmountingbracketalongtubeuntil
closureplateinbottomofhopperjustcloses.
c. Snugthe1/4"nylockhexnutsjustenoughtohold
owcontrolmountingbracketinplace.
d. Set adjustablestop at "5". Pull ow controlarm
againststop.Verifythatclosureplatehasopened
abouthalfway.
e. If closure plate does not open half way, adjust
positionofowcontrolmountingbracketuntilclosure
platewillopenabouthalfwayat"5"andwillclose
completelyinthe"OFF"position.Tightenthe5/16"
nylockhexnuts.
FIGURE 10
FLOW
CONTROL
ARM
OFF
ON
1
2
3
4
6
7
8
9
10
5
ADJUSTABLE
STOP
(SETTING "5")
ON
OFF
0
FIGURE 8
FIGURE 9
13. AssemblethetwoINNERhitchbracestotheowcontrol
mountingtubeusinga1/4"x1-3/4"hexboltanda1/4"
nylockhexnut.DO NOT TIGHTEN YET.Seegure8.
14. TIGHTENallnutsandboltsassembleduptothispoint.
Do not collapse the tubes when tightening.
15. Assemblethehopperstraptoholesintopofhopper
using two 1/4" x 2" hex bolts, small washers, nylon
washers,and1/4"nylocknuts.Seegure9.
1/4 x 1-3/4
HEX BOLT
1/4 NYLOCK NUT
1/4-20 x 2 HEX BOLT
1/4 NYLOCK NUT
SMALL WASHER
NYLON WASHER