Use and Care Manual

4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(2) 7/16"Wrenches
(2) 1/2"Wrenches
(2) 9/16"Wrenches
REMOVAL OF PARTS FROM CARTON
Removeallpartsandhardwarepackagesfromthecarton.
Lay out all parts and hardware and identify using the
illustrations on page 2.
FIGURE 1
FIGURE 2
FIGURE 3
4. AttachtheendsofthetwoOUTERhitchbracestothe
hitchtubeusinga1/4"x1-3/4"hexboltanda1/4"nylock
hexnut.DO NOT TIGHTEN YET.Donotattachtheinner
hitchbracesatthistime.Seegure2.
1. Turnthespreaderupsidedownasshowningure1.
2. Removethelocknutandwasherfromthemiddleboltin
thecrossovertube.Leavetheboltinplace.Seegure1.
3. Assemble the hitch tube onto the middle bolt and
secureitwiththesamelocknutyouremoved.DO NOT
TIGHTEN YET.Seegure1.
IMPORTANT:Thehitchtubemustattachtothesameside
ofthecrossovertubeastheshaftsupportplate.
ENGLISH
MIDDLE BOLT
HITCH
TUBE
1/4 NYLOCK
NUT
1/4 x 1-3/4
HEX BOLT
5. Assembleawasher,aspacer,awasher,awheel,and
anotherwasherontotheendoftheaxle.Seegure3.
6. Installa1/8"x1-1/2"cotterpinintotheholeintheendof
theaxleandsecureitbyusingplierstobendtheends
aroundtheaxle.Seegure3.
WHEEL
SPACER
WASHER
WASHER
WASHER
1/8 x 1-1/2
COTTER PIN