Use and Care Manual

5
Look for this symbol to point out important
safety precautions. It means -- attention!
Become alert! Your safety is involved.
CAUTION: Vehiclebrakingandstabilitymay
beaffectedwiththeadditionofanaccessory
or an attachment. Be aware of changing
conditions on slopes.
Exercisecautionatalltimeswhenusingpowerequipment.
1. Readthisownersmanualbeforeattemptingtoassembleoroperatethecart.
2. Readthevehicleownersmanualandknowhowtooperateyourtractor,beforeusingthecartattachment.
3. Donotatanytimecarrypassengersinthiscart.Ithasnotbeendesignedtocarrypassengers.
4. Neverallowchildrentooperatethetractororthecartattachment.
5. Donotallowadultstooperatethetractororcartattachmentwithoutproperinstructions.
6. Alwaysbeginwiththetransmissioninrst(low)andgraduallyincreasespeedasconditionspermit.
7. Towthecartatreducedspeedoverroughterrainandhillsidesornearcreeksandditchestopreventtippingoverand
lossofcontrol.Donotdrivetooclosetoacreekorditch.
8. Vehiclebrakingandstabilitymaybeaffectedwiththeattachmentofthiscart.Donotllcarttomaximumweightcapacity
withoutcheckingthecapabilityofthetowingvehicletosafelypullandstopwiththecartattached.
9. Beforeoperatingvehicleonanygrade(hill)refertothesafetyrulesinthevehicleowner’smanualconcerningsafeopera-
tiononslopes.Referalsototheslopeguideonpage7ofthismanual.Stay off steep slopes!
10. Donottowthiscartonhighwaysoronpublicthoroughfares.
11. Maximumtowingspeedis10m.p.h.
12. Followmaintenanceandlubricationinstructionsasoutlinedinthismanual.
ASSEMBLY INSTRUCTIONS
4. (Figure 3) Assemblethehitchbrackettothetongue
usingtwohexbolts(C)andhexnuts(I).Tighten.
5. (Figure 3) Assemble the hitch pin (L) through the
tongueandhitchbracketandsecureitwith the hair
cotter pin (J).
6. (Figure 4) Laythetongue(opensidefacingup)onto
thewheelsupport.Assembletheaxlethroughthewheel
supportandthetongue.
7. (Figure 5) Assembleanaxleclip(N),awasher(E),
a wheel withthe valve stem facingout, and another
washer(E)ontotheaxle.Securetheminplacewitha
1/8”x1-1/4”cotterpin(K).Repeatforotherwheel.
8. (Figure 6) Assemblethelatchstandplateandthelatch
standbracketatthefrontofthetrayusingfourhexbolts
(A)andhexnuts(F).Thealigningtabonthebottomof
thelatchstandbracketmustbetowardstherearofthe
cart. Tighten.
9. (Figure 7) Placethetrayontothewheelsupportand
positionitsothatthelatchstandbracketlocksintothe
latchlocklever.Fastenthetraytothewheelsupport
usingeighthexbolts(B)andhexnuts(G).Tighten.
(Assembly drawings are on pages 3 and 4.)
TOOLS REQUIRED FOR ASSEMBLY
(1) Screwdriver
(1) Pliers
(2) 7/16”Wrenches
(2) 1/2”Wrench
(2) 9/16”Wrenches
1. Verifythatallpartsandallfasteners(shownfullsize)on
page2areincludedinthecartonandpartsbag.Refer
to page 2 to identify fasteners used in the following
instructions.
2. (Figure 1) Placethelatchlockleverthroughtheslot
inthetongue.Assemblethehexbolt(D)throughthe
tongue,thelever,andtwohexnuts(H)placedoneach
sideofthelever.Assemblethehexnut(G)ontothe
endof the hex bolt (D)and tighten sothat the hex
bolt(D)canstillrotatefreely.Tightenthetwohexnuts
(H)againsteachsideoftheleversothattheleveris
centeredintheslot.
3. (Figure 2) Hooktheshortendofthespring(M)into
theholeinthelatchlocklever.Usethespringpullertool
(O)tohookthelongendofthespringintothesquare
holeinthetongue.Thespringpullertoolcanbestored
whennished.
SAFETY RULES
Remember,anypowerequipmentcancauseinjuryifoperatedimproperlyoriftheuserdoesnotunderstandhowtooperate
theequipment.Exercisecautionatalltimeswhenusingpowerequipment.
ENGLISH