Replacement Part List

14 Section 4 — ASSembly & inStAllAtion
6. Attach the retainer strap on the discharge chute to the
retainer clip on the deck. Refer to Figure 4-23.
Note: For the chute elbow to be properly installed, the
bottom edge must fall below the bottom of the deck
opening and the tab on top of the elbow should rest above
the deck opening.
Figure 4-23
7. Install the chute adapter onto the chute elbow by lining up
the tabs and sliding the adapter over the chute elbow, as
in Figure 4-24. Secure the chute adapter by installing two
ratchet clips (726-3046), included in hardware pack 689-
00163, into the holes provided.
Figure 4-24
NOTE: Check the upper chute for a cardboard insert
installed for shipping purposes. If the insert is present,
remove it before continuing with Step 8.
8. Peel the backing off of the self-adhesive foam strip (721-
04388) that has been included with your grass collector.
Apply it to the upper chute, flush against the flange as
shown in Figure 4-25.
Flange
Figure 4-25
9. With the bagger cover open, install the upper chute over
the chute adapter, and rest the top so that the chute
support sits in the upper chute groove. See Figure 4-26.
Note: Make sure to align the upper chute with the ridges
on the bagger support bracket, as shown in the inset of
Figure 4-26.
Figure 4-26