Installation Guide

3InstallatIon
Material Spreader Installation
1. Attach the motor assembly to the bottom
inside of the hopper by threading four M6
x 20 bolts through and connecting with flat
washers and M6 locknuts. See Figure 1-5
Figure 1-5
2. Slide the motor wire connector end through
the hole at the back of the hopper.
3. Fit the rubber grommet around the rim of the
hole to keep material from falling out.
9
1
8
7
4
3
6
5
11
10
12
2
Contents of Spreader Assembly
Ref. Part Number Description Qty.
1 3008791 Hopper 1
2 3008792 Restrictor Plate 1
3 3007863 Spinner Disc 1
4 3008793 Motor 1
5 3008801 Motor Cover, Top 1
6 3008802 Motor Cover, Bottom 1
7 3008796 Bracket, Motor Mount 1
8 3032808 Single Frame Tube 2
9 3032811 Switch Kit 1
10 3008803 Control Handle 1
11 3007869 Control Plate 1
12 3008797 Control Rod 1
NS 3031680 Switch Harness 1
NS 3031679 Battery Harness 1
NS 3008808 Hardware Bag 1
4. Secure the spinner disc to the motor shaft with
a cotter pin. See Figure 1-6.
Figure 1-6
5. Attach the hopper assembly to the round ends
of the single frame tubes with four M6 x 40
bolts and locknuts. See Figure 1-7.
Figure 1-7
NOTE: The indented side of the tubes should
be facing in.
6. Use two carriage screws and locknuts per
side to attach the indented ends of the single
frame tubes, to the top of the EZ Connect
Hitch Bracket. See Figure 1-8.
Figure 1-8
7. Use two M6 x 40 bolts and locknuts to attach
the control plate to the right side of the frame.
See 1 in Figure 1-9.
NOTE: The slot should face up, and the bolts
and locknuts should be secured through the
holes at the bottom corners of the plate.
8. Insert carriage bolt through the slot in the
control plate and secure with a plastic spacer
and wingnut to create an adjustable stop for
the control handle. See 2 in Figure 1-9.
9. Mount the control handle to the control plate
using a washer (between the control handle
and control plate) and a wingnut. See 3 in
Figure 1-9.
1
2
3
Figure 1-9
10. Insert the control rod (hook side) into the
restrictor plate (preattached beneath the
hopper) from the top down. See 1 in Figure
1-10.
11. Insert the flattened (90° angle side) of the
control rod into the control handle. See Figure
1-10
1
2
Figure 1-10
NS = Not Shown