Use and Care Manual

9Section 4 — ASSembly & inStAllAtion

Figure 4-5

6. Using a 1/2” wrench or socket, secure the hanger assembly

to the upright mounting assembly using another (710-0276)

carriage bolt from hardware pack 689-00328A and flange

lock nut packed in with the upright mounting bracket. See

Figure 4-6 .

Note: Upon completion of this bagging unit, there will be

one(1) extra wing knob from Hardware pack 689-00328A

and two(2) carriage bolts and one(1) flange lock nut, that

was packed in with the upright mounting bracket.

Figure 4-6

Note: The clevis pin can be fed down through the hitch

plate and secured underneath with the hairpin clip, or it

may be easier to feed the clevis pin up through the hitch

plate hole and secure with the hairpin clip on the topside.

The latter method may be preferred since it can be easier

to insert the hairpin clip. Either way will work, the decision

should be based on operator preference. The clevis pin has

two holes. It is recommended to use the hole closest to the

head of the pin for a tighter connection.

Figure 4-4

Note: If you decided to leave the hitch support only

finger tight during the assembly process, tighten all of the

hardware securely at this time.

4. Install the bagger upright mounting bracket onto the

mounting assembly of the tractor by hooking it over

the hitch plate, aligning the center hole on the upright

bracket with the hole on the cross mount bracket which

corresponds with the deck size of your tractor. See Figure

4-5.

• Hole A recommended for 50” & 54” decks

5. Secure the upright mounting bracket to the mounting

assembly using a (710-0276) carriage bolt and a (720-04122)

wing knob from hardware pack 689-00328A. Refer to

Figure 4-5.

Note: Some kits may contain cross-mount brackets with

numerical identification over the holes instead of letters as

shown. If this is the case, use the hole corresponding to the

deck size the bagger is being installed on.