Use and Care Manual

13Section 4 — ASSembly & inStAllAtion
IMPORTANT: Be certain that the bottom of the discharge
chute is located inside of the lip of the deck opening, as shown in
Figure 4-21.
Figure 4-21
7. With the bagger cover open, insert the upper chute tube
into the discharge chute then pivot the upper chute tube
into position so that the chute rests in the upper chute
support. See Figure 4-22.
Note: Make sure to align the upper chute with the ridges
on the upper chute support.
Figure 4-22
8. Close the grass catcher cover.
4. Insert the end of the discharge chute elbow (1) into the
hole provided in the deck wheel mount as shown in the
inset of Figure 4-19.
Do Not Use This Hole!
1
2
Figure 4-19
5. Pivot the discharge chute rearward until the hole in the
discharge chute elbow aligns with the pin on the deck
adapter. Move the discharge elbow down onto that pin as
shown in 2 of Figure 4-19.
6. Secure the discharge chute elbow to the cutting deck using
a (720-04122) wing knob included in hardware pack 689-
00341. Refer to Figure 4-20.
Figure 4-20