Use and Care Manual
12 Section 4 — ASSembly & inStAllAtion
6. Secure the discharge chute elbow to the cutting deck using
a (720-04122) wing knob included in Hardware Pack 689-
00341. Refer to Figure 4-17.
Figure 4-17
On 50” and 54” Stamped Decks:
1. Raise the deck to its highest position.
2. Remove the deck pin rubber protective cap, 1 in Figure
4-18.
3. Raise the chute deflector (2 in ) on the deck and hold it
while you install the (731-10133) chute adapter(3), included
in hardware pack 689-00341, onto the deck as shown in
Figure 4-18.
1
3
2
Figure 4-18
Installing the Discharge Chute
When installing the discharge chute, two different installation
instructions exist. For the 54” Fabricated deck units, the
discharge chute elbow mounts directly onto the cutting deck.
For the 50” and 54” stamped decks, an adapter must first be
installed. Be sure to follow the instructions that pertain to the
unit you are installing this bagger on.
54” Fabricated Deck Units:
1. Raise the deck to its highest position.
2. Remove the deck pin rubber protective cap, 1 in Figure
4-16.
3. Raise the chute deflector (2 in Figure 4-16) on the deck and
hold it while you position the discharge chute over the
chute opening.
2
4
1
3
Do Not Use This Hole!
Figure 4-16
4. Insert the end of the discharge chute elbow(3) into the hole
provided in the deck wheel mount as shown in the inset of
Figure 4-16.
5. Pivot the discharge chute rearward until the hole in the
discharge chute elbow aligns with the pin on the deck.
Move the discharge elbow down onto that pin as shown in
4 of Figure 4-16.