Use and Care Manual

11Section 4 — ASSembly & inStAllAtion
8. Install the bag assemblies, with the tight mesh panel facing
the tractor, onto the bag support brackets by inserting the
front edge in first, as shown in 1 of Figure 4-14, and setting
the back edge down(2) until it fits into the assembly.
1
2
Figure 4-14
Assembling and Configuring the Discharge Chute
Before installing the discharge chute onto your tractor, a
component must first be assembled onto the upper chute tube.
The following instructions for assembling and configuring the
discharge chute:
Note: Check the upper chute for a cardboard insert installed
for shipping purposes. If the insert is present, remove it before
continuing with Step 1.
1. Peel the backing off of the self-adhesive foam strip that
has been included with your grass collector. Apply it to the
upper chute, flush against the flange as shown in Figure
4-15.
Figure 4-15
Figure 4-11
Figure 4-12
7. Open Hood by pushing in on the rear, right-side tab with
your right hand, as seen in 1 of Figure 4-13, and lifting the
cover with your left hand in the center rear of the bagger
cover, 2.
1
2
Figure 4-13