Instructions / Assembly

Installing the Left Side Bracket
Remove the Left Side Hardware
Remove the following from the left side of the upper 1.
handle. See Fig. 6.
Two 1/4-20 screws•
Two flat washers•
Two 1/4-20 cap lock nuts.•
Two Jam Nuts•
Discard the screws and jam nuts, but retain the two flat washers
and two cap lock nuts.
Installing the Left Bracket
Position the rod assembly [C] between the metal panel and 2.
the plastic panel cover while aligning holes in rod assembly
with holes in the panels and securing with the following
hardware. See Fig. 7:
Two 1/4-20 x 1.75” screws [F]•
Two flat washers [H]•
Two flat washers retained from disassembly•
Two 1/4-20 cap lock nuts retained from disassembly•
Tightening the Handle Knobs
Tighten the four star knobs loosened in step 2.1.
Jam Nuts
Screws
F
H
Figure 6
Figure 7
4 se c t i O n 2— as s e M b l y & se t -up