Instructions / Assembly

Installing the Right Side Bracket
Shut off engine and disconnect the spark plug wire.1.
Loosen the four star knobs by turning the knobs 2.
counterclockwise five full rotations. See Fig. 3.
Removing the Right Side Hardware
Remove the following from the right side of the upper 3.
handle. See Fig. 4.
Two 1/4-20 screws•
Two flat washers•
Two 1/4-20 cap lock nuts.•
Two Jam Nuts•
Discard the screws and jam nuts, but retain the two flat washers
and two cap lock nuts.
Installing the Right Bracket
Position the rod assembly [C] between the metal panel and 4.
the plastic panel cover while aligning holes in rod assembly
with holes in the panels and securing with the following
hardware. See Fig. 5 and Fig. 6.:
Two 1/4-20 x 1.75” screws [F]•
Two flat washers [H]•
Two flat washers retained from disassembly•
Two 1/4-20 cap lock nuts retained from disassembly•
Figure 4
Figure 5
Figure 5
Jam Nuts
Screws
Rod
Assembly [C]
Plastic Outer Panel
Metal Inner Panel
F
H
Figure 3
3se c t i O n 2 — as s e M b l y & se t -up