Twin Rear Bagger Kit Operator's Manual

ManualsBrandsCub Cadet ManualsLawn Mower190-670-100

Operator’s Manual

PRINTED IN U.S.A.

FORM NO.

769-00657

(1/2003)

Twin Rear Bagger Kit

Models

190-670-100

and

190-678-100

IMPORTANT: Read safety rules and instructions carefully

Warning:

This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered,

brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state

laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the

above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply

on federal lands. A spark arrester for the muffler is available through your Cub Cadet dealer or contact the service department, P.O. Box

361131 Cleveland, Ohio 44136-0019.

Cub Cadet LLC., P.O. Box 361131, Cleveland, Ohio 44136-0019

Summary of content (12 pages)

PAGE 1
Operator’s Manual Twin Rear Bagger Kit Models 190-670-100 and 190-678-100 IMPORTANT: Read safety rules and instructions carefully Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
PAGE 2
TABLE OF CONTENTS Content Page Important Safe Operation Practices................................................................... 3 Loose Parts ....................................................................................................... 6 Assembly & Operation ....................................................................................... 7 Parts List............................................................................................................ 10 Warranty................
PAGE 3
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol—heed its warning.
PAGE 4
27. Use only accessories and attachments approved for this machine by the machine manufacturer. Read, understand and follow all instructions provided with the accessory or attachment. 28. Data indicates that operators, age 60 years and above, are involved in a large percentage of tractor-related injuries. These operators should evaluate their ability to operate the tractor safely enough to protect themselves and others from serious injury. 29.
PAGE 5
or trailer bed with a plastic liner. Always place containers on the ground away from your vehicle before filling. c. When practical, remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then refuel such equipment on a trailer with a portable container, rather than from a gasoline dispenser nozzle. d. Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete.
PAGE 6
SECTION 2: LOOSE PARTS The grass catcher kit is shipped with following loose parts in the carton. Please remove all loose parts from the carton before discarding it. Compare with Figure 1 to check that no parts are missingfrom the kit or have been misplaced during unpacking.
PAGE 7
SECTION 3: ASSEMBLY & OPERATION NOTE: References to LEFT, RIGHT , FRONT and REAR of the tractor are from the operator’s position. • Before assembly, place the tractor on a firm and level surface, disengage the PTO, stop the tractor engine and set the parking brake. IMPORTANT:There are two holes in the clevis pin. Be sure to insert the hairpin clip in the upper hole to properly secure the bracket assembly to the hitch plate.
PAGE 8
• Attach the grass bags using the slots shown in Figure 5. Close the grasscatcher cover. Chute Deflector Attaching the Discharge Chute • • Raise the deck to its highest position. On older models: Remove the clip, if already installed on the deck next to the discharge chute opening, by removing the lock nut, spring washer and hex bolt that secure it. See Figure 6A.
PAGE 9
Attaching Blades (Model 190-678 only) NOTE: The hex flange nut has a right-handed thread pattern. Do NOT attempt to force the nut in the incorrect direction. Doing so may damage the nut and create a safety hazard. Remove the blades from your tractor’s cutting deck as follows. • • • Remove the cutting deck from beneath the tractor, (refer to Deck Removal in the Maintenance section of your tractor’s operator’s manual for detailed instructions) then gently flip the deck over to expose its underside.
PAGE 10
SECTION 4: PARTS LIST 17 16 8 14 19 11 6 25 2 7 4 3 9 18 13 24 1 12 11 5 10 5 26 10 23 15 27 20* 21* * Model 190-678 only 10
PAGE 11
Model 190-678-100 Ref. No. Part No. 16587D 1. 16592 2. 664-04017 3. 710-0751 4. 710-3008 5. 710-3015 6. 711-0309A 7. 711-1421 9. 10. 712-3004A 11. 712-3027 12. 714-0117 13. 714-0145 14. 723-04008 15. 726-3040 16. 731-04159 731-04153 17. 731-0926B 731-0899E 18. 736-0331 19. 736-3092 20. 742-3010 21. 742-3011 23. 783-0601 24. 783-0673 25. 783-0764 26. 783-0765 27. 864-0221 Description Support Bracket Support Assembly: Grasscatcher Cover Cover Assembly: Grasscatcher Hex bolt: 1/4-20 x .
PAGE 12
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Cub Cadet LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Cub Cadet LLC warrants this product against defects for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in materials or workmanship.