Manual

Fuse
ill&i WARNING! Before servicing, repairing, or
inspecting, always disengage PTO, set parking
brake, stop engine and remove key to prevent
unintended starting.
A 20 Amp fuse is installed in your tractor's wiring harness to
protect the tractor's electrical system from damage caused by
excessive amperage.
If the electrical system does not function, or your tractor's engine
will not crank, first check to be certain that the fuse has not
blown. It is located under the hood, mounted behind the top of
the dash panel on the support bar.
i_i CAUTION: Always use a replacement fuse with the
same amperage capacity as the blown fuse.
Tires
WARNING! Never exceed the maximum inflation
pressure shown on the sidewall of the tire.
The recommended operating tire pressure is approximately 10
psi for the rear tires and 14 psi for the front tires. Refer to the
tire sidewall for exact tire manufacturer's recommended or
maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to mow
unevenly.
Changingthe TransmissionDrive Belt
Several components must be removed and special tools used in
order to change the tractor's transmission drive belt. See your
Cub Cadet dealer to have the transmission drive belt replaced
Changingthe DeckBelt
2.
F
not disengaging completely. For a proper working
machine, use factory approved belts.
All belts on your tractor are subject to wear and should be
replaced if any signs of wear are present. To change or replace
the deck belt on your tractor, proceed as follows:
1. Remove the deck as instructed on page 24.
Remove the belt covers by removing the hex washer
screws that fasten them to the deck. See Fig. 7-7.
WARNING! The V-belts found on your tractor are
specially designed to engage and disengage safely.
A substitute (non-OEM) V-belt can be dangerous by
Belt Cover
He× Washer Screws
Spindle Pulley
,Belt Guard
Figure 7-7
3. It may also be necessary to loosen the hex nut on the left
idler pulley to get the belt off the pulley and around the
belt guard.
4. Carefully remove the deck belt from around the two
spindle pulleys and the two deck idler pulleys. See Fig. 7-7.
5. Remove the deck belt from around the two spindle pulleys
and the two deck idler pulleys.
SECTION7 -- SERVICE 27