Operator's Manual SERIES 1000 Hydrostatic Lawn Tractor Models LT1042 LT1045 LT1046 LT1050 IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should net be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
TABLEOFCONTENTS Content Important Safe Operation Practices Slope Guage Tractor Set-up Know Your Lawn Tractor Operating Your Lawn Tractor Making Adjustments Maintaining Your Lawn Tractor Page 3 Content Service Page 21 7 8 Off-season Storage Maintenence Chart 26 26 9 12 Troubleshooting Attachments & Accessories 27 28 17 19 Warranty Information 27 FINDINGMODELNUMBER This Operator's Manual is an important part of your new lawn tractor.
SECTION1: IMPORTANT SAFEOPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol--heed its warning.
23. Mufflerandenginebecomehotandcancausea burn.Donottouch. 24. Checkoverhead clearances carefullybeforedriving underlowhangingtreebranches, wires,door openingsetc.,wheretheoperatormaybestruckor pulledfromtheunit,whichcouldresultinserious injury. 25. Disengage allattachment clutches,depressthe brakepedalcompletely andshiftintoneutralbefore attempting to startengine. 26. Yourmachineis designedtocutnormalresidential grassofa heightnomorethan10".Donotattempt tomowthroughunusually tall,drygrass(e.g.
e. Useextremecarewhenapproaching blind corners,doorways, shrubs,treesor other objectsthatmayblockyourvisionofachild whomayrunintothemachine. f. Toavoidback-overaccidents,always e. f. g. disengage the cutting blade(s) before shifting into reverse, The "Reverse Caution Mode" should not be used when children or others are around, g. h. Keep children away from hot or running engines. They can suffer burns from a hot muffler. allow space for fuel expansion. Replace gasoline cap and tighten securely.
8. Nevertamperwiththesafetyinterlocksystemorother safetydevices.Checktheirproperoperationregularly. 9. Afterstrikinga foreignobject,stoptheengine, disconnect thesparkplugwire(s)andgroundagainst theengine.Thoroughly inspectthemachineforany damage.Repairthedamagebeforestartingand operating. 10. Neverattempttomakeadjustments or repairstothe machinewhiletheengineisrunning. 11. Grasscatchercomponents andthedischarge coverare subjecttowearanddamagewhichcouldexpose movingpartsorallowobjectstobethrown.
Sight and hold this 1evenwith a verticantree... or a corner of a building.,. m_ or a fence post | | 1 a 15° | ILl _L ..,.I &i Z I-I,l.I p..
SECTION3: TRACTOR SET-UP GasandOilFill-up The gasoline tank is located under the fender and has a capacity of three gallons. Unthread the fuel cap by turning it counterclockwise. Use only clean, fresh (under 30 days old), unleaded gasoline. Fill tank to no more than four inches below the top of the filler neck to allow space for fuel expansion. Do not overfill. ,_ handling gasoline. extremely WARNING: Use Gasoline extreme iscare when flammable and the vapors are explosive.
SECTION4: KNOWYOURLAWNTRACTOR A B C H NOTE: Steering Wheel not shown for clarity. Figure 1 A B Systems Indicator Monitor/Hour Meter Throttle Control Lever H I PTO (Blade Engage) Knob Brake Pedal C Choke Control J Drive Pedal D Parking Brake Lever K Cruise Control Lever E Fuel Tank Cap L Deck Lift Lever F Seat Adjustment Lever M Cup Holder G Ignition Switch Module NOTE: Any reference in this manual to the RIGHT or LEFT side of the tractor is observed from operator's position.
ThrottleControlLever The throttle control lever is located on the left side of the IgnitionSwitch Module Fast Position WARNING: Never leave a running machine unattended. Always disengage PTO, move shift lever into neutral position, set parking brake, stop engine and remove key to prevent unintended starting. tractor's dash panel. This lever controls the speed of the engine. When set in a given position, the throttle will maintain a uniform engine speed. See.
HourMeter ElectricPTO/ BladeEngageKnob Located in the center of the tractor's console, the hour meter operates whenever the engine is running and records the actual hours of tractor operation. See Figure 3. To engage the power to the cutting deck or other (separately available) attachments, pull outward on the PTO/Blade Engage knob. Push the PTO/ Blade Engage knob inward to disengage the power to the cutting deck. 234.
SECTION5: OPERATING YOURLAWNTRACTOR WARNING: WARNING AVOIDSERIOUS INJURYORDEATH • • • • • • • • • • • • GO UP AND DOWN SLOPES, NOT ACROSS. AVOID SUDDEN TURNS. DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR TIR IF MACHINE STOPS GOING UPHILL, STOP BLADE(S) AND BACK DOWNHILL SLOWLY. DO NOT MOW WHEN CHILDREN OR OTHERS ARE AROUND. NEVER CARRY CHILDREN, EVEN WITH BLADES OFR LOOK DOWN AND BEHIND BEFORE AND WHILE BACKING. KEEP SAFETY DEVICES (GUARDS, SHIELDS, AND SWITCHES) IN PLACE AND WORKING.
• If the gauge wheels have excessive clearance with the surface below, lower the wheels to the index hole that provides the approximate 1/2" clearance as described above. Refer to Levelingthe Deckon page 17 of this manual for more detailed instructions regarding various deck adjustments. SettingtheGaugeWheels Select the height position of the cutting deck by placing the deck lift lever in any of the six different cutting height notches on the right fender.
• EngagingtheParking Brake To engage the parking brake: • Fully depress the brake pedal and hold it there while gently pushing the parking brake lever downward. IMPORTANT: Do NOT attempt to change the direction of travel when the tractor is in motion. Always bring the tractor to a complete stop before pivoting the drive pedal from forward to reverse or vice versa. • Hold the parking brake lever down while removing your foot from the brake pedal.
• • Depress the brake pedal to disengage the cruise control and stop the tractor. Lightly depress the drive pedal. IMPORTANT: Never attempt to move the tractor manually without first opening the hydrostatic relief valve. Doing so will result in serious damage to the tractor's transmission. To change the direction of travel to reverse when operating with cruise control, depress the brake pedal to disengage the cruise control and bring the tractor to a complete stop.
• • • • • • For best results it is recommended that the first two laps be cut with the discharge thrown towards the center. After the first two laps, reverse the direction to throw the discharge to the outside for the balance of cutting. This will give a better appearance to the lawn. Do not cut the grass too short. Short grass invites weed growth and yellows quickly in dry weather. Mowing should always be done with the engine at full throttle.
SECTION6: MAKINGADJUSTMENTS • Locate the two lock nuts on the opposite side of the stabilizer bracket. See Figure 10. Tighten the lock nuts to raise the front of the deck; loosen the lock nuts to lower the front of the deck. • Retighten the two jam nuts loosened earlier when proper adjustment is achieved. adjustments engineto ismake running, WARNING: while Nevertheattempt any except where specified in the operator's manual.
ParkingBrakeAdjustment HexNut and LockWasher WARNING: Never attempt to adjust the brakes while the engine is running. Always disengage PTO, stop engine and remove key to prevent unintended starting. J PivotBar If the tractor does not come to a complete stop when the brake pedal is completely depressed, or if the tractor's rear wheels can roll with the parking brake applied, the brake is in need of adjustment. The brake disc can be found on the right side of the transmission in the rear of the tractor.
SECTION7: MAINTAININGYOURLAWNTRACTOR • Service the oil filteras instructed in the separate Kohler Owner's Manual packed with your unit. Perform the above steps in the opposite order after oil has finished draining. NOTE: Refer to MaintenanceCharton page 26 for a reference of recommended maintenance intervals. WARNING: Before performing any maintenance or repairs, disengage PTO, set parking brake, stop engine and remove key to prevent unintended starting. • Refill the engine with new motor oil.
Lubrication WARNING: Before lubricating, repairing, or inspecting, always disengage PTO, set parking brake, stop engine and remove key to prevent unintended starting. Engine Refer to Engineon page 19 for instruction regarding all engine-related lubrication. Pivot Points & Linkage Lubricate all the pivot points on the drive system, parking brake and lift linkage at least once a season with light oil.
SECTION8: SERVICE Tires Place a block of wood between the center deck housing baffle and the cutting blade to act as a stabilizer. See Figure 17. inflation pressureNever shownexceed on the the sidewall of the WARNING: maximum tire. ,_ HexFlangeNut The recommended operating tire pressure is approximately 10 psi for the rear tires and 14 psi for the front tires. Refer to the tire sidewall for exact tire manufacturer's recommended or maximum psi. Do not overinflate.
Battery CuttingDeckRemoval The battery is sealed and is maintenance-free. Acid levels cannot be checked and fluid can not be added. To remove the cutting deck, proceed as follows: • Place the PTO/Blade Engage knob in the disengaged (OFF) position and engage the parking brake. • Lower the deck by moving the deck lift lever into the bottom notch on the right fender. • Remove the deck belt from around the tractor's electric PTO clutch (refer to Changing the BeckBelt).
Hydrostatic Transmission Changingthe DeckBelt Keep the area around the transmission cooling fan free of grass and debris at all times. The hydrostatic transmission is sealed at the factory and is maintenance free. The fluid level cannot be checked and on most models, cannot be changed. ,_ If your tractor is equipped with a transmission drain plug (see Figure 19), exposed to extreme conditions (hilly terrain, towing, etc.
46-inch Decks 50-inch Decks • • Insert a 3/8"-drive ratchet wrench (set to loosen) into the square hole found in the idler bracket on the left side of the deck's surface. See Figure 21. To ease in removing the belt in later steps, loosen, but do not remove, the bolt which secures the pivoting idler pulley to the idler bracket. See Figure 22.
LT1842 LT1845& LT1846 LT1858 25
SECTION9: OFF-SEASON STORAGE Clean and lubricate the tractor as instructed in Section7: MAINTAINING YOURLAWNTRACTORon page 19 of this manual before storing for an extended period. To empty the system, run the engine until the tank and system are empty. WARNING: Drain fuel only into an approved container outdoors, away from an open flame. Allow engine to cool. Extinguish cigarettes, cigars, pipes, and other sources of ignition prior to draining fuel.
SECTION11: TROUBLESHOOTING Trouble Possible Engine fails to start PTO/Blade Engage knob engaged. Parking brake not engaged. Spark plug wire(s) disconnected. Throttle control lever not in correct starting position. Choke not activated Fuel tank empty, or stale fuel. Blocked fuel line. Faulty spark plug. Engine flooded. Unit running with CHOKE activated. Spark plug wire(s) loose. Blocked fuel line or stale fuel. Engine runs erratic Corrective Cause(s) Vent in gas cap plugged.
SECTION12: ATTACHMENTS & ACCESSORIES The following attachments and accessories are compatible for Series 1000 Lawn Tractors.
SECTION13: SPECIFICATIONS LT1042 LT1045 LT1046 LT1050 Capacities Fuel Tank 13.2 liters (3.5 gallons) Engine Crankcase (w/filter) Transmission 1.5 liters (50.75 oz) 13.2 liters (3.5 gallons) 2.25 liters (76 oz) 2.25 liters (76 oz) Make and Model Hydro-Gear311-0510 Gear Ratio 22.2:1 Forward Speed Reverse Speed Hydrostatic 13.2 liters (3.5 gallons) .5 liters (50.75 oz) 13.2 liters (3.5 gallons) 2.0 liters (67.6 oz) 2.25 liters (76 oz) 2.
FEDERAL KOHLER CO. AND CALIFORNIA EMISSION CONTROL SYSTEMS LIMITED WARRANTY UTILITY AND LAWN AND GARDEN ENGINES The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Kohler Co. are pleased to explain the FederaI and California Emission Control Systems Warranty on your small off-road equipment engine. For California, engines produced in 1995 and later must be designed, built and equipped to meet the state's stringent anti-smog standards.
MANUFACTURER'S CUB CADET LLC ONE YEAR LIMITED WARRANTY (COMMERCIAL USE) The limited warranty set forth below is given by CUB CADET b. LLC ("CUB CADET") with respect to new merchandise purchased and used in the United States, its possessions and territories. blade adapters, grass bags, rider deck wheels, seats, snow thrower skid shoes, shave plates and tires.
CUB CADET LLC MANUFACTURER'S LIMITED WARRANTY (RESIDENTIAL The limited warranty set forth below is given by CUB CADET LLC ("CUB CADET") with respect to new merchandise purchased and used in the United States, its possessions and territories.