Manual

Lowe

Handle

Handle Mountin

Bracket

Clip

Figure 5

After you have moved the hairpin clips, place one

carriage bolt (included in the hardware pack) in the

upper hole of the right handle mounting bracket

from the inside outward. See Figure 6. Secure with

one plastic wing nut. Repeat process on the left.

CableTie

Lowe_

Handl

Figure 7

NOTE: Make sure the drive cable is routed around the

outside and above the lower handle so as not to

interfere with the grass bag attachment.

The rope guide, which is connected to the support

rod, is located on the right side of the lower handle.

See Figure 8.

With the spark plug wire disconnected and

grounded, hold the blade control handle against the

upper handle, and pull the starter rope out of the

engine. Release the blade control handle. Slip the

starter rope into the rope guide. See Figure 8.

Figure 6

Attach control cables to handle by inserting post of

cable ties into the holes on the lower handle. The

holes may be on either side of the handle. Pull

cable ties tight and cut off the extra. See Figure 7.

Starter

Rope

Guide

Figure 8

_Support

Rod