Manual

CAUTION: Do not oil foam element.
PaperElement
* Clean the paper eiement every 100 hours.
, Clean the element bytapping genttyto remove
dust. If very dirty, replace the element with a new
one.
, Replace with a new paper-element yearly or 300
hours.
CAUTION: Do not wash paper-element.Do not use
pressurized air to clean or dry paper element.
NOTE: Operating in a dusty condition may require
more frequent maintenance than above.
4
4
Reinstall the foam element and then the paper
element on the air cleaner body.
Reinstall the air cleaner case on the air cleaner
body by first fitting the projection (B) on the edge of
the air cleaner case into the slit (A) in the air cleaner
body. Then, sliding the fasteners (C) toward the air
cleaner case, securely fasten the air cleaner case
with the air cleaner body.
Figure 16
* Checkthe spark plug gap and reset it if necessary.
The gap must be between 0.7 and 0.8 mm (0.028
and 0.032").
To change the gap, bend only the side-electrode, using
a spark plug tool.
-Install and tighten the spark plug to 23 N-m (2.3kgf-m,
17fMb).
-Fit the spark plug cap on the spark plug securely.
-Pull up the spark plug cap lightly to make sure of the
installation of the spark plug cap.
RecommendedSparkPlug
NGK... BPR5ES
A. Slit in the air cleaner body
B. Projection on the air cleaner case
C. Fasteners
CAUTION: After servicing the air cleaner, be sure
all the removed parts are reinstalled properly in
place. Failure to secure fastening of the air cleaner
case with the air cleaner body may cause dirt or
other foreign materials to enter the engine, while it
is running, through the air cleaner, resulting in
engine troubles or failures.
4
4
4
4
WARNING: Hot engine components can
cause severe burns. Stop engine and allow itto
cool before checking spark plug.
Clean or replace the spark plug and reset gap (A)
every 100 hours of operation.
Disconnect the spark plug cap from spark plug and
remove the spark plug.
Clean the electrodes (B) by scraping or with a wire
brush to remove carbon deposits.
Inspect for cracked porcelain or other wear and
damage. Replace the spark plug with a new one if
necessary.
Figure 17
A. Spark Plug Gap
B. Electrodes
CAUTION: Be sure to use the same type of spark
plug for change. Resistor spark plug is required in
some areas by local law.
Storage
Engine to be stored over 30 days should be completely
drained offuel (gasoline) to prevent gum deposits
forming on essential carburetor parts and the fuel
system.
,_ WARNING: Gasoline is extremelyflammable and can be explosive under certain
conditions. Drain gasoline before storing the
equipment for extended periods. Drain
gasoline in a welt-ventilated area away from
any source offlame or sparks, including any
appliances with a pilot light. Store gasoline in
an approved container in safe location.
° Remove the spark plug cap from spark plug to
prevent accidental starting the engine.
° Empty the fuel from the fuel tank with a pump or
siphon.
° Fit the plug cap on the spark plug securely
° Start and run the engine at idle speed to used up
the fue! in the fuel system.
,_ WARNING: Before maintaining engine, stop
the engine and allow it cool.
31