Manual

A.BrakeControlLever
B.Handle
Figure 10
Adjustment
EngineSpeedAdjustment
NOTE: Do not tamper with the govemor setting or the
carburetor setting to increase the engine speed. Each
carburetor is adjusted at the factory with either a cap or
stop plate installed on the mixture screw. Any
adjustments must be performed an authorized
Kawasaki dealer.
MAINTENANCE
Check oil level and add
engine oil
Check for loose Or lost
nuts and screws
Check for fuel and oil
leakage
Check for brake control
lever function
Check or dean recoil
starter and air intake
screen Tighten nuts and
screws
*, Clean air cleaner foam
element
*,Clean air cleaner paper
element
Change an#iRe oil
Clean and re-gap spark
Plug
*, Replaae ai_ cleaner
paper element
4, Clean dust and dirt from
cylinder and cylinder head
fins
*,Clean combustion
chamber
*,Check and adjust valve
clearance
*,Clean and lap valve
seating surface
DAILY
MAINTENANCE
INTERVAL
FIRST8 EVERY25 EVERY50
HOURS HOURS HOURS
Periodic Maintenance Chart
EVERY
100
HOURS
EVERY
200
HOURS
EVERY
300
HOURS
NOTE: The service intervals indicated are to be used as a guide. Service should be performed more frequently as
necessary by operating condition. Service more frequently under dusty conditions.
:l:: Have an authorized Kawasaki dealer perform these services.
Oil LevelCheck
Check oil level daily and before each time of operation.
Be sure oil level is maintained. See PREPARATION.
0il Change
Change oil after first 8 hours of operation. Thereafter
change oil every 50 hours.
_hl ARNING: Hot engine oil can cause severeburns. Allow engine temperature to drop from
hot to warm before draining and handling oil.
o Run the engine to warm oil.
, Be sure the engine (equipment) is level.
° Stop the engine.
29