Manual

speeds.Itmaycausedamagetothemower,andcould
breakcausingpersonalinjury.
Thebladecanbetestedbybalancingit onaround
shaftscrewdriver.Removemetalfromtheheavyside
untilitbalancesevenly.Itisrecommendedthatthe
bladealwaysberemovedfromtheadapterwhen
testingforbalance.Beforereinstallingthebladeand
thebladeadaptertotheunit,lubricatetheengine
crankshaftandtheinnersurfaceofthebladeadapter
withlightoil.
Besuretoinstallthebladewiththesideofthe
blademarked"Bottom"(orwithpartnumber)facing
thegroundwhenthemowerisintheoperating
position.
Slidethebladeadapterontotheenginecrankshaft.
Placethebladeontheadapter.Becertainthe
bladeisalignedandseatedonthebladeadapter
flanges.
Placebladebellsupportonblade.Makesurethe
notchesonthebladebeltsupportarealignedwith
smallholesintheblade.
Replacehexboltandtightentotorque:450in.Ibs.
min.,600in.lbs.max.
NOTE:To ensure safe operation of your mower, the
blade bolt must be checked periodically for correct
torque.
DriveBeltRemovaland Replacement
Disconnect the spark plug wire and ground it
against the engine.
Drain the fuel tank or place a piece of plastic
beneath the cap to prevent gasoline leakage.
Place shift lever in the first position and tip the
mower on its side with air filter facing up.
Remove the center bolt which secures the blade to
the crankshaft followed by blade bell support,
blade, and blade adapter.
Move the cutting height adjustment to the highest
position.
Remove the three hex screws holding the baffle to
the deck and pivot baffle towards the rear of the
mower. See Figure 17.
Remove the hex bolt from the rear of unit holding
the transmission to the mower housing.
See Figure 18.
Cutting Height
Adjustment
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
Bolt
Figure 18
Tilt the transmission forward and loosen the idler
pulley bolt and lock nut half a turn. See Figure 19.
Using a pair of pliers, pull back and rotate belt
keeper bracket from the slot on the idler pulley.
Slide the belt out from between the belt keeper
bracket and the idler pulley.
Transmission
Pulley
Belt--.
Belt Keeper_
Bracket
Idler
Bracket
Bolt and f
Locknut
\
\
\
Transmission
f
J Baffle
Figure 17
Figure 19
Squeeze the belt together and push it forward,
while pressing the control arm inward towards the
deck and remove the six speed cable from the slot.
See Figure 20.
Pivot the control arm down away from the pulley
and belt.
Lift off the lower pulley assembly and remove the
old belt from around the crankshaft. See Figure 20.
14