Specifications

LUBRICATION GUIDE
(InternationalCub Cadet 123 Tractor)
_--After Every 10 Hours of Operation
1. Oil filler cap and bayonet-type
oil level gauge.
2. Steering knuckles (2).
3. Front axle pivot pin.
4. Transmission oil filter°
Check the oil (with the engine stopped) and add sufficient
new oil to bring it to the "FULL" mark on the gauge. Do
not overfill. Do not operate the engine if the oil level is
below the "LOW" mark on the gauge.
Use IH-Z51 HEP grease or equivalent #Z multi-purpose
lithium grease and apply sufficient grease to flush out old
grease and dirt.
Note: After the first 10 hours only, remove the old filter
and replace with a new filter as instructed on page 27.
Change the oil filter after 50 hours and every 100 hours
of operation thereafter.
--After Every 30 Hours of Operation
5. Engine crankcase.
While the oil is warm, remove the drain plug (5) and
drain all of the oil from the crankcase. Replace the drain
plug. Remove the crankcase oil filler cap (1). Refill the
crankcase with new oil up to the "FULL" mark on the oil
level gauge. Refer to the "Lubrication Table" for the
proper quantity and viscosity to use.
--After Every 50 Hours of Operation
6. Transmission oil filter.
Note: After the first 50 hours only, remove the old filter
and replace with a new filter as instructed on page 27.
Change the oil filter every 100 hours of operation
thereafter.
Transmission oil filter.
_--After Every 100 Operation
Hours of
l Change the oil filter and replace with a new filter as
instructed on page 27.
Transmission
8. Oil level and filler plug.
O --Periodic
Check the oil level periodically or once a year. Keep the
lubricant up to the level plug (8) on the rear of the trans-
mission case cover.
31