Phau Ntawv Qhia

ManualsBrandscua sov ManualsWiring Centreheatmiser UH8-RF V2 Wiring Centre

Slimline-RF V1\V2 Setup & Pairing

Step 1 Setup. With the thermostat turned OFF:

• Press & hold the Clock button until you see two sets of numbers appear *................................................................

The small number 01 in the top right corner of the LCD is the feature number.

• Press Clock repeatedly until you see feature 06 (Receiver Type) .....................................................................................

The options within feature 06 are: 00 = UH8-RF or 01 = UH8-RF v2/RF-Switch receiver.

• Use the Up/Down keys to set feature 06 to 01 (UH8-RF V2/RF-Switch) ...............................................................

• Press Clock again until you see feature 07 (Receiver Address) .........................................................................................

You can now select a zone number from 01-08. To save confusion, set this address to the same zone

number you will be pairing to on the UH8-RF V2. If you have a second UH8-RF V2, you would choose

numbers 9 to 16 and so on for each additional wiring centre.

• Use the Up/Down keys to set feature 07 to 01 ..............................................................................................................

(You must set a unique zone number address for each thermostat installed).

• Press A to conﬁrm settings and the display will go blank .................................................................................................

If in mode 02, the secondary timer will automatically be paired to Hot Water channel.

Step 2 Pairing.

• On the UH8-RF V2, press and hold the desired zone pairing button for 5 seconds or until the zone light ﬂashes

steadily.

• With the thermostat turned OFF, press & hold the A button for 5 seconds..................................................................

• The thermostat will send a signal for 1 minute and will ﬂash the RF signal icon**....................................................

If pairing is successful, the ﬂashing light on the UH8-RF V2 will go out almost immediately.

If pairing is unsuccessful, check features 06 to 07 have been conﬁgured correctly. To eliminate a possible signal

issue, reposition the thermostat closer to the receiver and repeat the pairing process again.

Note: the maximum number of Slimline-RF thermostats on this system is 32.

*Feature Menu

**Active Pairing

Wiring Centre2 12