Technical data

12.4.2002 Rev. 2.0

Troubleshooting

6. Troubleshooting

Error codes are used in troubleshooting to indicate a possible problem and/or corrective

action. These codes are shown in the MenuSelect display and are explained in the follow-

ing chart.

An authorized service representative must be contacted for any failures that cannot be

remedied by reprogramming.

Do not remove access panel at rear of control compartment. High voltage exists inside

compartment which can cause serious injury or danger to life.

DISPLAYED ERROR CODE EXPLANATION CORRECTIVE ACTION

E-00 Programming selections lost Re-enter MenuSelect programs

E-01 High ambient Condition. Temperature in-

side control enclosure exceeds 65°C. Oven

shuts down and beeps continuously.

Check axial cooling fan at top of con-

trol box for proper operation and

cleanliness. If fan is not running or

oven stays in the high ambient mode

call your local authorized service

agent.

E-02 Conveyor Runaway. Conveyor runs full

speed. Oven shuts down and beeps contin-

uously.

Check for proper speed setting. If

speed setting is correct call your local

authorized service agent.

E-04 Conveyor Jammed. Conveyor stopped

when speed setting is between 01:00

minute and 30:00.

Clear item that is jammed conveyor.

If conveyor still does not operate call

your local authorized service agent.

E-35 Top Heating Zone Failure Call your local authorized service

agent.

E-36 Bottom Heating Zone Failure Call your local authorized service

agent.

E-40 Heating Zone Temperature High Limit.

One or both heating zones greater than

526°C. Oven shuts down and beeps con-

tinuously.

Call your local authorized service

agent.