Technical data

12.4.2002 Rev. 2.0
Installation
27
Overcurrent protector must be in OFF position and oven disconnected from power supply
when removing or servicing the appliance. Professional should disconnect the oven from
its power supply.
5.5 Programming the G-26 MenuSelect Control Oven
The oven controller controls all functions of the oven. To operate the oven the controllers
must be programmed. The following pages contain a step by step “hands on” program-
ming exercise. We invite you to actually program your oven by following examples.
This exercise assumes first time start after installation. Programming from factory is 93°C
temperature settings and 2 minute cook times.
1. Turn Oven Deck ON
Turn ON the main disconnect switch at the wall box.
Place the key into the slot in the control board located below the keypad and turn
it to the vertical position.
Press ON/OFF rocker switch to ON position. Oven will startup in a preset default
of 93°C for top and bottom zones and at a 2 minute cook time. Control will display
- - - -. You are now ready to proceed with programming.
2. Choose a menu selection to program
Press and hold key (or any other preset menu key 1-5) until P-- # appears in
the display and begins to flash. The number in the display (# is shown above) will
match the menu key that was pressed (1-5).
3. Set top temperature
Press key. The current top set temperature appears in the display.
Press and keys as necessary to change the displayed temperature.
• Pressing key once increases the “active” (flashing) digit by one. This
digit “rolls over” to its minimum value if the key is pressed when the digit
shows its maximum value.
• Pressing key once causes the next digit to the right to become “ac-
tive” (flashing) digit. If the far-right digit is flashing when the key is
pressed, the far-left digit will flash and become the “active” digit.
4. Set bottom temperature
Press key. The current bottom set temperature appears in the display.
Press key and key as necessary to change the displayed temperature.