Technical data

12.4.2002 Rev. 2.0
Installation
24
5.2.3 Conveyor Belt and Temperature Display
The conveyor belt is designed to travel in either direction using the conveyor Reversing
Key Switch. The temperature display may be set for either °F or °C. Your Certified In-
staller will set both of these functions for you during the installation. If you require a
change in the degrees display (Fahrenheit or Centigrade) in the future call your local Au-
thorized Service Agency.
5.2.4 Standoffs
If the back side of the oven will be against a wall the four (4) standoffs supplied in the
installation kit must be mounted to the rear panel of oven. To install the standoffs remove
one rear panel screw at a time and replace with a standoff as shown in the figure below.
These standoffs will keep the ventilation louvers on the rear control compartment panel
from being blocked.
Placing the oven directly against a wall without the standoffs will block the vent louvers
and will not allow hot ambient air in the control compartment to escape. The compartment
would then overheat and cause possible damage to electrical components.
Leave at least 50 mm space between the oven and the back wall.