Technical data

12.4.2002 Rev. 2.0
Installation
22
5.2 Installation
5.2.1 Installing Legs
Install the four 4” adjustable legs as shown in the figure below then lift the oven onto it’s
legs. On single oven installation place the oven in it’s permanent position.
5.2.2 Stacking and Mounting Two Ovens
A stacking pins kit (Kit # G26STACK) is required when stacking two ovens.
1. Move the lower oven (oven with legs installed) to it’s permanent position. Remove
the two plug buttons, one located in each rear top corner hole of lower oven.
2. Unpack the upper oven. Locate the two (2) stacking pins in the kit. Install the two
pins into the two bottom rear threaded holes of the upper oven. These are the holes
normally used for the rear legs.
3. Using four people lift the upper oven on top of the lower oven. Align the stacking
pins as shown in the figure below with the holes in the top of the lower oven and
lower the oven into place.