Technical data

12.4.2002 Rev. 2.0
Installation
20
5. Installation
5.1 Unpacking the oven
The oven components should be moved as close as possible to final location before being
assembled/stacked. The oven setting on its bottom, requires door openings wider than
679mm.
Open carton and remove it from around oven, then remove the empty carton from the area.
Directions for removing the wooden skid are on the following page.
Attached to the conveyor belt is a box containing one (1) short exit tray, one (1) long exit
tray, two (2) pivoting heat curtains, four (4) adjustable 10cm legs, four (4) standoffs and
two (2) sets of keys. (See the figure below). Check to make sure you received the correct
quantity of parts.
1
3
4
2
5
6