User`s manual

1. INTRODUCTION

Thank you for using the 8 Ports 10/100/1000Base-T plus 1 Port 1000Base-X or

100/1000Base-X Uplink, or 9 Ports 10/100/1000Base-T Ethernet Managed Switch. The built-

in management module allows users to configure this Switch and monitor the operation status

locally or remotely through network.

The Managed Switch is fully compliant with IEEE 802.3 and 802.3u standards. By employing

store and forward switching mechanism, the Switch provides low latency and faster data

transmission. Moreover, it also supports more advanced functions such as QoS, Q-in-Q

VLAN Tunneling, Rate Limiting, IGMP Snooping, etc.. Users can configure the required

settings of the Switch and monitor its real-time operational status via Command Line Interface

(CLI). For detailed descriptions on how to use CLI, please refer to Section 2.

1.1 Interfaces

Depending on the main device and optional accessories that you purchased, the front panel

and rear panel of your Switch may look differently from model to model. Figure 1 to 4 show

the front and rear panel for 9-Port 10/100/1000Base-T Ethernet Managed Switch in stylish

plastic housing or metal housing respectively; whereas, Figure 5 to 8 show the front and rear

panel for 8-Port 10/100/1000Base-T plus 1-Port 1000Base-X or 100/1000Base-X Uplink

Ethernet Managed Switch with optional CATV RF module in stylish plastic housing or metal

housing.

Figure 1. Front Panel for 9-Port 10/100/1000Base-T Managed Switch (plastic housing)

Figure 2. Rear Panel for 9-Port 10/100/1000Base-T Managed Switch (plastic housing)

Figure 3. Front Panel for 9-Port 10/100/1000Base-T Ethernet Managed Switch (metal housing)

Figure 4. Rear Panel for 9-Port 10/100/1000Base-T Ethernet Managed Switch (metal housing)

Smart Lighting Control

10/100/1000Mbps RJ-45 ports

Smart Lighting Control

Grounding Wire