User`s manual

57
Storm Rate: Set up storm rate value. Packets exceeding the value will be dropped.
Broadcast: Select Enabled to receive, or Disabled to reject broadcasts.
Multicast: Select Enabled to receive, or Disabled to reject multicasts.
Unknown Multicast: Select Enabled to receive, or Disabled to reject unknown multicasts.
Unknown Unicast: Select Enabled to receive, or Disabled to reject unknown unicasts.
Click the “OK” button to apply the settings.
3.4.3 Port Configuration
Click the option Port Configuration from the Switch Management menu and then the
following screen page appears.
Port Number: Click the pull-down menu to select the port number for configuration.
Port State: Enable or disable the current port state.
Preferred Media Type: This shows the media type (either Fiber or Copper) of the selected
port. This field is open to select only when ports of the device have two media type.
Port Type: Select Auto-Negotiation or Manual mode as the port type.
Port Speed: When you select Manual port type, you can further specify the transmission
speed (10Mbps/100Mbps/1000Mbps) of the port(s).
Duplex: When you select Manual port type, you can further specify the current operation
Duplex mode (full or half duplex) of the port(s).
Flow Control: Enable or disable Flow Control function.
Click the “OK” button to apply the settings.