User`s manual

44
Switch(config)# show interface
statistics clear
Clear all statistics.
2.5.19 Show sfp Command
When you slide in SFP transceiver, detailed information about this module can be viewed by
issuing this command.
2.5.20 Show log Command
2.5.21 Show running-config & start-up-config Command
Command
Description
Switch(config)# show running-config
Show configurations currently used in
the Managed Switch. Please note that
you must save running configurations
into your switch flash before rebooting
or restarting the device.
Switch(config)# show start-up-config
Display system configurations that are
stored in flash.
Command
Description
Switch(config)# show sfp information
Display the slide-in SFP information
including speed, distance, vendor
name, vendor PN and vendor serial
number.
Switch(config)# show sfp state
Display the slide-in SFP information
including temperature, voltage, TX bias,
TX power, and RX power.
Command
Description
Switch(config)# show log
Show event logs currently stored in the
Managed Switch. The total number of
event logs that can be displayed is 500.