User`s manual

40
Switch(config-user-
USERNAME)#
description [description]
[description]
Enter the brief description for this user
account.
Switch(config-user-
USERNAME)# level
[admin | rw | ro]
[admin | rw | ro]
Specify user account level. By default, when
you create a community, the access privilege
for this account is set to “read only”.
Admin: Full access right, including
maintaining user account, system
information, loading factory settings, etc..
rw: Read & Write access privilege. Partial
access right, unable to modify system
information, user account, load factory
settings and upgrade firmware.
Ro: Read Only access privilege.
Switch(config-user-
USERNAME)# password
[password]
[password]
Enter the password for this user account up
to 20 alphanumeric characters.
No command
Switch(config)# no user
name [user_name]
[user_name]
Delete the specified user account.
Switch(config-user-USERNAME)# no
description
Remove the configured description.
Switch(config-user-USERNAME)# no
level
Remove the configured level value. The
account level will return to the default setting.
Switch(config-user-USERNAME)# no
password
Remove the configured password value.
Show command
Switch(config)# show
user name [user_name]
[user_name]
Show the specified account‟s information.
Switch(config)# show user name
List all user accounts.
Switch(config-user-USERNAME)# show
Show or verify the newly-created user
account‟s information.
User command example
Switch(config)# user name miseric
Create a new login account “miseric”.
Switch(config-user-USERNAME)#
description misengineer
Add a description to this new account
“miseric”.
Switch(config-user-USERNAME)# level
rw
Set this new account‟s access privilege to
“read & write”.
Switch(config-user-USERNAME)#
password mis2256i
Set up a password for this new account
“miseric”