User`s manual

84 • vacon CONTROL KEYPAD
Tel. [phone] • Fax [phone]
9
Figure 9-13. Parameter comparison
9.3.6.5 Security
NOTE: The Security submenu is protected with a password. Store the password in a safe place!
Password (S6.5.1)
The application selection can be protected against unauthorised changes with the Password function
(S6.5.1).
By default, the password function is not in use. If you want to activate the function, enter the edit
mode by pushing the
Menu button right . A blinking zero appears in the display and now you can set a
password with the
Browser buttons . The password can be any number between 1 and 65535.
Note that you can also set the password by digits. In the edit mode, push the Menu button right once
again and another zero appears on the display. Now set first the units. Then push the Menu button
left and you can set the tens etc. Finally, confirm the password setting with the
Enter button . After
this, you have to wait until the
Timeout time (P6.6.3) (see page 87) has expired before the password
function is activated.
If you now try to change applications or the password itself you will be prompted for the current
password. The password will be entered with the
Browser buttons .
Deactivate the password function by entering the value 0.
Figure 9-14. Password setting
Note! Store the password in a secure location! No changes can be made unless a valid password is
entered!
C1 C3
READY
READY
READY
0
enter
P1P6
P2.1.2= 50.0
READY
20.0 Hz
P2.1.2= 50.0
READY
20.0 Hz
ParamComparison
Set1
Set1
CONFIRM CHANGE
EDIT VALUE
OR
READY
I/Oterm
0
READY
I/Oterm
enter
00
READY
I/Oterm
enter
Password
Not in use
Password Password
OR: