User guide
CTI Products, Inc. SLM SiteLync
TM
User Guide
Appendix C. SLM/Config utility 17
Parameters may also be saved to a file using the Save File As item of the File
menu.
Modem Options
Country (EU Analog Only)
European Union compatible modems allow a specification to enable country
specific line requirements. Test the SLM SiteLync first using the “Europe”
selection. If the connection is not satisfactory, select the actual country of
location from the drop-down list. Europe is the default selection.
Auto Answer
If the SLM Network Modem must automatically answer incoming calls, select
“Auto Answer”. Auto Answer enabled is the default state.
Answer/Originate Mode (Analog Leased Lines Only)
In leased line op
eration, it is suggested that the SLM SiteLync network modem
operate in Answer Mode. Answer Mode is the default state. The modem at the
host PC should be placed in Originate Mode.
Pulse Dial (Analog Dial-Up Only)
If the SLM Network Modem must use pulse d
ialing (as opposed to the more
common tone dialing), select “Pulse Dial”. Pulse Dial disabled is the default
state.
B Channel Protocol (ISDN Only)
The Bearer (B) Channel is used for transmitting data on the ISDN line. A variety
of protocols are used to fo
rmat the data on the B Channel. Specify the protocol
to match the protocol used in the ISDN modem connected to the host PC to
which the SLM SiteLync will communicate.
D Channel Protocol (ISDN Only)
The Delta (D) Channel is used for call supervision and co
ntrol, and the
activation/deactivation of ISDN features. A variety of protocols are used to
format the data on the D Channel. Specify the protocol required by the ISDN
line provider.
Extra Settings
In some cases, additional initialization commands are ne
eded to configure the
SLM Network Modem to customer specific requirements. When specified in this
text box, these characters are appended to the dial string, and appear in the
“Resulting Modem Settings” box. Normally, this box should be left blank.
Resulting Modem Settings
This read-
only line shows the complete initialization string to be downloaded to
the SLM SiteLync.