User guide

CTI Products, Inc. SLM SiteLync
TM
User Guide
Appendix A. SLTALink Manager and NSI Mode 11
Figure 7. NSI Mode with Host PC using SLTALink Manager
Establishing a New Local Link
Use this procedure when the SLM SiteLync SETUP OR HOST
port is connected
directly to the PC COM
port via an RS232 cable. For the SLM/AY, be sure that
OPTION switch position 2 is in the UP position. For all other models, be sure
that the RUN/CFG switch is in the CFG position. Following
any change to
switch settings, be sure to power cycle or RESET the SLM SiteLync.
To establish a new local link with an SLM SiteLync using SLTALink Manager,
use the following steps:
a. From the Link menu, choose New.
b. In the “Link Description” window, specify a Name, click the Local button,
then click the Next button.
c. In the “Comm Port” window, specify the serial port to which the SLM
SiteLync will be connected, select a baud rate of 57600, then click the Next
button.
d. In the “Link Properties” window, accept the default field values by clicking
the Finish button.
e. From the Link menu, choose Select and select the link just configured from
the list .
f. Manually connect to the local SLM by clicking the “Link” button shown
here. Connection status will be indi
cated in the main window. If
successful, the “Remote Identifier” will be shown.
PSTN
Standard
Modem
Host PC
EIA-232
Interface
LonWorks
Nodes
SLM-IM
Host Application
LNS Software
SLTALink Manager
and
LDVVDD.SYS
Network Driver