User Manual

MCN Remote Comparator Display Running the MCN Comparator Display
CTI Products, Inc. (MCNRCD) Program
68-10856-210
47
The Receiver Indicators display the status of the receivers. The following status
indications can be displayed:
Status Indicator Background
color
Text Color
No Activity Blue
Vote Vote Green White
Receiving Rx Lt Gray Dark Gray
Disabled Dis Yellow Black
Failed Fail Red White
Error Err Brown Yellow
Transmitter Selected Tx Magenta White
Vote + Tx Selected Tx/Vote Green White
Receiving + Tx Selected Tx/Rx Lt Gray Dark Gray
Disabled + Tx Selected Tx/Dis Yellow Black
Failed + Tx Selected Tx/Fail Red White
Table 1 - Receiver States
The last 5 items listed in Table 1 are used to show a transmitter’s status along
with the corresponding receiver’s status. This transmitter status will only be
displayed if the Comparator I/O Module monitoring the receivers is also operating
with a TSAM Interface Module (TIB) to provide monitoring and control of
transmitter sites (see section 2.3).
7.5 Controlling Receivers
You can use the MCNRCD program to control the receiver operation at your
remote comparator. You can manually FORCE VOTE a receiver from the PC and
listen to its audio quality over your system. You can also DISABLE a receiver
that is defective or has a bad phone line. When the receiver or phone line is
repaired, you can re-enable the receiver from the PC.
7.5.1 Controlling Receivers With The Mouse
The mouse is used to force vote sites and to disable sites from the main receiver
screen.
To Force vote (monitor) a receiver:
To force vote a site, place the mouse cursor over a receiver and click the left
mouse button. The receiver will remain voted as long as you hold the left mouse
button.
To Disable a receiver:
To disable a site, place the mouse cursor over a receiver and click the right mouse
button. The receiver will remain disabled.