Owner's manual

Installation
19 68-11824-210
Finally, click the Test button to display status information similar to the following window.
When finished, click the OK button on this “LON1 Diagnostics” window, then click the OK button on
the “LonWorks Plug ‘n Play” window.
If the PCLTA network interface card was installed prior to device driver installation, the PCLTA may
not function correctly. To correct this situation, see Error! Reference source not found. on Page Error!
Bookmark not defined..
Cabling and Termination
The PCLTA card is different from all other MCN modules in that it does not have an RJ-45 connector
for the network cable to plug into. A ‘T’ Adapter (S2-60617), shown below, must be installed to
connect the PCLTA’s two-pin connector with the MCN network cable. Use one RJ-45 connector on this
adapter for the network cable, and plug a terminator (either TP/XF1250 or TP/FT10) into the other.
CA-80273-101
CABLE