Owner's manual

Appendix: Accessory DOS Programs
160 68-11824-210
Running HIB Configure
Perform the following steps to program a HIB-232 module with the modem "AT" command string:
1. Connect the HIB-232 module to the serial port specified above for the ctihib.sys driver in the
CONFIG.NT file.
2. Ensure that OPTION A Switches 1 and 3 are UP, all others DOWN OPTION B switches
should all be DOWN. SER MODE switches should all be UP.
3. Apply power to the HIB-232.
4. Open a DOS window (click the Start button, select “Run…”, type “command” in the text
box, then click OK).
5. In the DOS window, navigate to the MCNRCD directory for DOS Utilities with the following
command:
cd C:\Program Files\CTI Products Inc\McnRcd Standard\Dos
Utilities\Hib
6. Type the following
hibcnfg /38400 usrspvi
then press the Enter key. “usrspvi” is the name of the file that contains the initialization string for a
generic V.34 US Robotics modem. If your modem is different, check with CTI Products to select
the most appropriate file.Placeholder for Section Header.