User guide

RadioPro Dispatch Installation and Configuration Guide
42
Telemetry Panel Configuration
The Telemetry Panel must be configured in order to show status or provide control for I/O points located in vehicles or
facilities.
I/O points can be provided using the following optional hardware interfaces:
 For vehicle I/O, a Tallysman Sprite must be connected to the mobile radio. Features include:
o 8 I/O points (3 inputs provided by Sprite, 5 I/O provided by radio).
o Store-and-forward for GPS and I/O data when radio is out of RF coverage.
o Buffering and acknowledgements by Sprite assures reliable control and status monitoring.
o Available for MOTOTRBO (TW200) and NEXEDGE (TW202).
o More information at: http://www.tallysman.com/lbwi-mototrbo.php
 For facility I/O, Advantech Adam 6000 modules must be connected via IP to the Dispatch PC. Features
include:
o Compact, isolated I/O, economical.
o Recommend models include:
ADAM-6050, 12 inputs, 6 outputs
ADAM-6052, 8 inputs, 8 outputs
ADAM-6060, 8 inputs, 6 relay form A outputs
o More information at: http://www.advantech.com/products/data-acquisition-
modules/sub_data_acquisition_modules.aspx
An example Telemetry Panel is shown in the following screenshot.
Use the following steps to configure the Telemetry Panel:
1. Configure the I/O modules.
a. Configure stand-alone IP-based Advantech modules using Adam/Apax .NET Utility.
i. Download the Adam/Apax .NET Utility from Advantech.com, or
http://support.advantech.com/support/DownloadSRDetail_New.aspx?SR_ID=1-
2AKUDB&Doc_Source=Download
ii. Connect power to the Adam module.
iii. Connect the Adam module to the IP network.
Telemetry
Panel