Installation guide

RadioPro IP Gateway Installation and Configuration Guide

RADIOPRO IP GATEWAY OPERATION

Power-up

The Power Button can be used to power up or power down the unit by pressing it momentarily.

A watchdog circuit built into the IP Gateway monitors program operation. If the watchdog circuit detects that the program

is not functioning correctly, it will re-initialize the IP Gateway. This process may take up to two minutes. During this

process, RadioPro Dispatch or Talk clients will not have a connection or communication with the Control Station radio.

Indicators

A blue LED located on the Power Button indicates that power is applied to the IP Gateway.

A red LED located internally, but viewable through the vents on the left side of the IP Gateway indicates the functioning

of the Hardware Watchdog as follows:

 “Slow Blinking” (2 seconds per blink) indicates that the IP Gateway is rebooting. This will normally occur

for a maximum of two minutes after power-up.

 “Steady” illumination indicates that the IP Gateway software and hardware is operating correctly, and

follows the “Slow Blinking” boot-up period.

 “Fast Blinking” (1 second per blink) indicates that the watch-dog circuitry has detected a problem, and that

re-booting will commence within 5 seconds.