Installation guide

RadioPro IP Gateway Installation and Configuration Guide
36
GPS tab
If mapping locations of subscribers is required, place a check
mark next to Enable GPS Updates. Since this option will
increase the amount of radio transmissions, leave this
unchecked if GPS mapping is not needed.
Then choose a Minimum Poll Rate to set the minimum time
between successive GPS updates. Increasing this parameter
will decrease the number of GPS updates, thereby allowing
more channel bandwidth for voice conversations.
BASIC RxTx
Basic RxTx tab
Four signals are required to be interfaced between a
generic radio and an IP Gateway:
Receive Audio, Transmit Audio, Carrier, and PTT.
More details about these signals can be found in the
Appendix. Use this tab to specify the active state for
the PTT and Carrier signals.
g. From the Gateway menu, click on Write Settings. Enter the Admin Gateway Password (factory default
password is “admin”), then close the configuration window for this IP Gateway.
h. Remove the Ethernet cable between the RadioPro IP Gateway and the local PC or laptop used for configuration.
Repeat the above steps for each RadioPro IP Gateway.