Installation guide

RadioPro IP Gateway Installation and Configuration Guide
35
5) Radio-Specific tabs
NEXEDGE
When an IP Gateway has been licensed for use with a
NEXEDGE radio, the following tabs will be allow parameter
input.
NEXEDGE Radio tab: Enter appropriate radio ID values for
the fields on this tab.
Zone/Channels tab: For each Zone programmed into
the Control Station radio, enter channel information
parameters.
MOTOTRBO
MOTOTRBO Radio tab
Use the ARS Subscriber Refresh Rate to set the time between
successive ARS (Automatic Registration Service) updates for
subscribers. The default value is 0.5 hours.
Other parameters on this tab are factory-default values, and
match the default parameters programmed into the Control
Station radio. Under normal circumstances, these values
should not be altered.
Zones/Channels Aliases tab
This list is downloaded from the connected MOTOTRBO radio
and will be displayed in a TurboVUi Dispatch client’s radio
controller. A Zone or Channel can be re-named by clicking on
it, then editing its name. If a name cannot be edited, be sure
that the MOTOTRBO radio is connected and powered on. In
Capacity Plus systems, the MOTOTRBO radio adds an
additional Zone to the list called “Channel Pool”. In most
cases, this should be hidden from the Dispatcher by clicking on
this “Channel Pool”, then removing the check mark in the
“Visible” box.