Installation guide

RadioPro IP Gateway Installation and Configuration Guide
27
3. Network folder:
a. Enter the ARS Radio ID. This should be the Radio ID of the Control Station radio that is connected to
the RadioPro IP Gateway.
b. Enter the TMS Radio ID. This should be the Radio ID of the Control Station radio that is connected to
the RadioPro IP Gateway.
4. Channels folder:
Make the following changes for each digital channel that will be used to transmit GPS coordinates:
a. Change ARS to “On System Change”.
b. If the repeater for this channel has the “Enhanced GPS Option”, enable Enhanced GPS by placing a
check mark in the box.
c. If Enhanced GPS is enabled in step b. above, then set the Window Size to either 5 or 6, depending on
the selection for Privacy Type. Note that the Window Size parameter is system-wide, and must also be
set in the Data Revert Repeater(s) to match this value. See the tables below for more details.
In the following Enhanced GPS Radio Update Tables, the number of radio GPS updates is indicated
based on selection criteria of Update Interval and Window Reservation.
Window Size = 5, Privacy Type must be None or Basic
Window
Reservation
Update
Interval
90% 75% 60% 45%
30 sec 90 75 60 45
1 min 180 150 120 90
2 min 360 200 240 18
4 min 720 600 480 360
8 min 1440 1200 960 720
3a.
3b.