Installation guide

RadioPro IP Gateway Installation and Configuration Guide

Step 1b. for MOTOTRBO

Configure MOTOTRBO Connect Plus Option Board

If this Control Station radio is being used in a Connect Plus system, then the Connect Plus Option Board must also be

configured. Use Connect Plus Option Board CPS version R01.30.100 (or later) to configure the Option Board using the

following steps. (CTI Cable S2-61431 may be used as a programming cable in lieu of the Motorola programming cable.)

1. Menu folder:

a. In the “Contacts” section, enable

Call Alert, Manual Dial, Radio

Check, Remote Monitor,

Radio Enable, and Radio

Disable.

b. In the “Call Log” section, enable

Missed, Answered, and

Outgoing.

2. Write the CPS parameters to the Connect

Plus Option Board. CTI Cable S2-61431

may be used as a programming cable in lieu

of the Motorola programming cable.

3. Remove the programming cable from the

Control Station radio. A programming cable

connected to the front mic connector on the

Control Station radio will prevent

communications to a RadioPro IP Gateway from the Rear Accessory Connector. Therefore, when a cable is

connected to the Rear Accessory Connector to connect a RadioPro IP Gateway or a PC (during programming), ensure

that the programming cable has been disconnected from the front mic connector.

1a.

1b.