Installation guide

RadioPro IP Gateway Installation and Configuration Guide

Step 1a. for NEXEDGE

Configure Control Station Radio(s) using KPG-111DN FPU Software

Use Kenwood’s NEXEDGE radio programming software (KPG-111DN) to configure NEXEDGE radio parameters using

the following steps.

Configure the control station as any other radio

1. Connect the NX-800 Control Station radio to a PC or Notebook that has Kenwood’s NEXEDGE radio

programming software (KPG-111DN) installed using a Kenwood programming cable or CTI radio interface cable #

S2-61769.

2. Open the KPG-111DN FPU.

3. Ensure that the correct COM port is selected by going to the Setup > COM port menu.

4. Then, from the Program menu, select Read Data from the Transceiver as shown below.

5. After the data has been read, use File > Import to load all of the necessary settings required for your radio system.

Parameters may also be entered manually.