Installation guide

RadioPro IP Gateway Installation and Configuration Guide
11
OTHER ITEMS NEEDED
Radio Interface Cable
A radio interface cable must be ordered from the following table:
Control Station Radio Cable Part #
Motorola XPR4550/5550, DGM5500/8500, DM4000, XiR M8260 S2-61431
Kenwood NEXEDGE NX-800 S2-61769
Generic radio using “Basic RxTx Interface” 89-12109
Control Station Radio
Each Control Station radio used for voice requires one IP Gateway.
The control station radio connected to the IP Gateway must at least have the minimum firmware version listed below.
Control Station Radio Minimum Version
Motorola MOTOTRBO in Conventional, IPSC, Cap+, or LCP 1.08.0
Motorola MOTOTRBO in Connect Plus mode 2.2.0
Motorola MOTOTRBO Connect Plus Option Board 1.3.0
Kenwood NEXEDGE NX-800 1.23.00
Radio Programming Cable
A radio programming cable is required to configure the Control Station radio.
Note: A programming cable connected to the front microphone connector on the Control Station radio may prevent
communications to a RadioPro IP Gateway from the Rear Accessory Connector. Therefore, when a cable is connected
to the Rear Accessory Connector to connect a RadioPro IP Gateway or a PC (during programming), ensure that
the programming cable has been disconnected from the front microphone connector.
Radio Programming Software
Motorola’s CPS (Customer Programming Software) utility or Kenwood’s NEXEDGE radio programming software
(KPG-111DN) is required to configure the Control Station radios radio for various RadioPro functions.
Laptop or PC
A laptop or PC will be needed to run the ICU.exe utility mentioned in the previous section.