Instruction Manual

MCN System Manual Hardware Installation
CTI Products, Inc.
68-10833-120
24
7.3.2 Rack Mounting
The rack mount option provides a 19” rack mounting bracket that supports four
MCN modules. Two types of rack mount brackets are available. One supports
four A size MCN modules and the other supports two A size and one B size MCN
modules (refer to Table 1, in section 1.3, to determine the size of your MCN
module). Figure 9 shows an exploded view of the rack mount installation. The
top diagram shows the front view of the bracket with one module installed. The
bottom two diagrams show a side view of the module installation and bracket
installation respectively.
CA-80021-100
IN OUTNETWORK
PWR
ACT
ERR
DC IN
OPTION A
RESET
SVC
12345678
ON
FACEPLATE
SPACER
PRODUCTS, INC.
Figure 9 - Rack Mounting - Front and Side View
To attach a module to the bracket, and then mount the bracket, follow the steps
below.
WARNING
Do not allow the PC board to slide out of the case when the front panel is
removed. If it does, DO NOT slide the PC board back into the case from the
front of the module. Doing so may damage the unit, causing the unit to
malfunction when powered on. Doing so will void the unit’s warranty.