Owner's manual

CTI Products, Inc. EXB-IP User Guide
IP Configuration – EXB Config 21
Step 3. Editing IP Address Parameters
The IP information that was gathered from the IP Network Administrator, as described at the beginning of
Section 2 of this manual, must be entered into the EXB Config program as follows:
a. Specify the Channel Global IP Parameters:
• If you wish to change the “Channel Name”, choose File – New Channel, enter an appropriate
name, then click OK.
• Click on the “Global IP Subnet Mask” textbox, then enter the Subnet Mask assigned the EXB-
IP modules by the IP Network Administrator.
• If different subnet masks are specified for different groups of EXB-IP modules, enter the
subnet mask that is common to most of the EXB-IP modules in the group.
• If a different subnet mask is assigned to every EXB-IP module, leave this field with its default
value.
• After reviewing the information concerning IP Addressing Modes in Appendix F, choose either
“Unicast/Replicated” or “Multicast” from the “IP Address Mode” drop-down list.
• If “Multicast” was selected above, click on the “Multicast IP Address” box and enter the
Multicast IP Address that the IP Network Administrator has assigned to this group of EXB-IP
modules.
b. Specify the “Channel Member List” parameters:
To enter a new EXB-IP member, right-click the Channel Member List table and select New Member...
from the drop-down list as shown below.
Enter the Member Name in the dialog box that is displayed;
The main screen will now be updated to show the new Member Name as shown below.