Owner's manual

CTI Products, Inc. EXB-IP User Guide
IP Configuration – EXB Config 16
IP SETTINGS WORKSHEET
After determining which IP addressing mode will be used (Unicast/Replicated or Multicast), gather the
following IP information for the system. IP information must be obtained for each EXB-IP module to be used
(from the network administrator responsible for the IP network to which the EXB-IP module will be attached):
System-Wide Parameters (for all EXB-IP modules)
Channel Name
Global Subnet Mask _____._____._____._____
IP Address Mode ____ Unicast Replicated or ____ Multicast
A Multicast IP Address
(only for Multicast Addressing Mode) _____._____._____._____
Central Site EXB-IP module Number
(For Unicast Replicated multipoint)
Destination UDP Port Number EXB-IP Legacy,
EXB-IP 8000 (for MSI Astro25™ V7.13 and up RNIs
Custom
Individual EXB-IP module Parameters (one for each module in your system):
EXB-IP module Number 1
EXB-IP unit Location (Member Name)
EXB-IP module IP Address
(Host IP Address)
_____._____._____._____
Subnet Mask
_____._____._____._____ or ____ Use Global
Gateway IP Address
_____._____._____._____
Target (Other EXB-IP untis to talk to)
____ All in Channel or ____ Central Site Only
EXB-IP module Number 2
EXB-IP unit Location (Member Name)
EXB-IP module IP Address
(Host IP Address)
_____._____._____._____
Subnet Mask
_____._____._____._____ or ____ Use Global
Gateway IP Address
_____._____._____._____
Target (Other EXB-IP units to talk to)
____ All in Channel or ____ Central Site Only
EXB-IP module Number 3
EXB-IP unit Location (Member Name)
EXB-IP module IP Address
(Host IP Address)
_____._____._____._____
Subnet Mask
_____._____._____._____ or ____ Use Global
Gateway IP Address
_____._____._____._____
Target (Other EXB-IP units to talk to)
____ All in Channel or ____ Central Site Only