User manual

Ctek Z4200 Series SkyRouter
Getting Started
October 11, 2009
Page 2 © 2009 Ctek Inc
Z4200U Connections
Figure 2
Switches and Indicators:
Switches
Referring to Figure 2, there are two switches on the front of the Z Series router. S1 (Reset)
causes a hard reset of unit. S2 (DFLT) is used to completely restore the firmware settings that
were included when the product was shipped from the factory. To restore factory defaults, the unit
must be running. Press the Restore Defaults (inner) switch and hold it down for 10 seconds. After
10 seconds, you will see both the green and yellow lights go off. At that time you may either press
the reset (outer) switch or cycle power on the unit.
Figure 3